WARNING
1. Keep
away from children
2. Contains flammable gas under
pressure, exercise care in use
3. Don’t perforate or
play with the lighter
4. Ignite lighter away from
face, hair and clothing.
5. Never expose to heat
above 120°F or 50°C or to prolonged sunlight
6. Never
puncture or put in fire
 FLAME ADJUSTMENT
1.
Adjust flame to desired height. Wind proof and touch
type lighters operate most efficiently when flame height
is 15-25MM.
2. Put one-line screwdriver inside the
adjuster at the bottom of the lighter:
Turn it
clockwise or near (-) position, the flame become
lower;
Turn it anticlockwise or near (+) position,
the flame become higher.
FILL THE
GAS
 1. Use butane gas.
2. Set flame
adjustment near (-) lowest position
3. All air must
be removed from gas tank in order to fill to maximum
capacity. Bleed only when flame begins to drop, and tank
is nearly empty.
4. Fill with lighter in an
upside-down position
5. Put nozzle tip directly on
valve opening, and press down firmly for 2-3 times, 2
seconds per time.
6. Butane spray-back may occur
with some lighters when full. If the lighter is not
equipped with a gas viewing hole, use the following
steps to ensure the gas tank is full:
Hold lighter
in an upright position. Depress the filler valve with a
ballpoint pen or small screwdriver until hissing
stops.
7. Warm the lighter in your hand for 10
seconds. Then, wait at least 1 minute before attempting
to ignite the lighter. This will allow enough time for
excess butane to dissipate, and gas in the lighter to
reach room temperature.
FLINT REPLACEMENT
WARNING
1. Set flame adjustment near (-)
lowest position
2. Remove flint screw, or slide flint
plunger back to expose flint chamber
3. Tap lighter
gently on a hard surface to remove flint particles, and
dust
4. Insert placement flint into flint
chamber
5. Replace flint screw, or slide plunger back
into place
6. Never force flint into flint
chamber
7. Clean the serrated flint wheel
occasionally with a stiff brush
CARE HAND
HANDLING
1. Keep away from
children
2. Never attempt near heat source, sparks or
flame
3. To preserve the finish, do not carry with
coins, keys and metal, as they will scratch the outer
surface. Clean the outer surface using only a soft,
clean dry cloth.
4. Be sure use certificate brand
butane, use of other brands of unknown pressures and
levels of contamination will clog the butane feeding
system, and affect the performance of the
lighter.
|
